Rear Crankshaft Seal Installer for Ford Similar to OTC 7834 (303-5524)

Description

Features
APPLICATION -- Specially designed for 1993-1997 Aerostar or 1993-2006 Ranger and Explorer with 4.0L V6 engine.
FUNCTION -- Rear Crankshaft Seal Installer works on crankshaft rear oil seals that come with or without a metal wear sleeve.
PRACTICLE -- Replace OTC 7834 Rear Crankshaft Seal Installer for Ford. Similar to Ford No. 303-5524.
MATERIAL -- Corrosion-resistant & Quality Steel construction with extreme anti-wear property.
SATISFACTION GUARANTEE -- If you are not satisfied with Camoo products, simply asked money back guarantee with 12 months warranty. No worry about buying!
Product description
APPLICATION:
1993-1997 Aerostar or 1993-2006 Ranger and Explorer with 4.0L V6 engine.
FEATURES:
1. Replace OTC 7834 Rear Crankshaft Seal Installer. Similar to Ford No. 303-5524.
Special service tool. Rear crankshaft seal installer is used for applications can come either with or without a metallic crankshaft sleeve.
INSTALLATION
1. The rear crankshaft seal adapter and 2 mounting screws attach to the crankshaft.
2. The threaded hole in the center of the crankshaft seal adapter is used by the rear crankshaft seal replacer to draw down and locate the crankshaft rear oil seal.
3. The rear crankshaft seal protector is used for installing seals without a metallic sleeve. It is not used when installing a rear main oil seal with a sleeve.
CAUTION: do not remove the metal sleeve from the seal.
This installation procedure requires the uesd of hand tools only. The used of power tools or hammering on the installer can damage the sleeve and seal.
Seal installation with metal sleeve
1. Attach the rear crankshaft adapter to the rear of the crankshaft using the supplied mounting screws.
2. Apply a few drops of clean engine oil to the inboard side of the seal/sleeve at the area where the seal contacts the sleeve.
3. Apply a very light film of clean engine oil onn the inner diameter of the sleeve and outeer diameter of seal.
4. Slide the seal/sleeve over the rear crankshaft seal adapter with flange to the rear of the engine.
NOTE: it is normal for the seal to sit approximately 0.76mm(0.030 inch) deeper than the sleeve flange. DO NOT ADJUST.
Use the rear crankshaft seal replacer and supplied bolt to push the rear seal into the cylinder block.
Remove rear crankshaft seal adapter.
Package includes
:
1 * 7834 Rear Crankshaft Seal Installer
We committed to providing you a more wonderful service concept.Thanks for your click!